Wire Mesh Common of Terms (Fence)

Crack: steel surface longitudinal cracks appear, crack, crack.

Crack (from thorn): wire visible surface appear lateral strip crack, showing barbed tongue or other shapes

Stratification: a partial longitudinal wire or through long division

Scarring (scar spot): yellow wire surface oxidation scars appear white lime scar

Pull marks: vertical steel surface presence of significant small ditch or ridge, minor who is not only the surface appears smooth shiny phenomenon.

Folding: the surface of the metal wire along the longitudinal direction of the overlap. Often has a straight shape but also a curved or zigzag-shaped formation. When metallographic examination, usually iron oxide inclusions and decarburization layer fold.

Concave: local depression on the wire surface.

Corrosion: steel surface partial and overall oxidation.

Ma points: steel surface when severe oxidation of punctate or patchy distribution of pits.

Bamboo: wire along the longitudinal cyclical uneven thickness, the shape of the United States like bamboo.

Spiral pattern: wire straightening process, the surface of the thread-like roll marks.


Scale: Oxidation occurs when contact with the steel surface temperature oxidation furnace gas to produce a layer of hard and easy fragmentation of the oxide.

Oxide film: a thin layer of dense steel surface oxide generated, this oxide is generally difficult to break, was affected only when bending or deformation can be partially peeled off.

Oxidation of color: a very thin surface layer of steel under the bright heat treatment conditions closely attached to the surface of the oxide wire.

Decarburization: When the wire is heated by the action of the gas medium and carbon steel layer, so that the surface area to reduce the carbon content, which reduces the amount of carbon surface phenomenon called decarbonization.

Graphitic carbon: the steel part or all of the carbon in the free state analysis, the presence of which in the free state of carbon is carbon black stone.

Loose side: net bulging wavy edge.

Diameter – is the wire diameter;

Warp – all longitudinal braided line;

Weft – All transverse braided wire;

Number of eye–1 Inch length of the mesh number of the mesh;

The number of the mesh density –1 cm length of

Mesh – the distance between two warp or weft between two

Tolerance – Comprehensive boxer when the vertical distance between the warp and tolerance at the line of heddles (MM)

Male line – over the chest before fruit (Rolla) connection

On tolerance – Fully usually higher than at warp heddles tolerance line

Lower tolerance – tolerance line called below the lower tolerance

Zero Tolerance – coincides with the line called zero tolerance tolerance

Fully angle – After opening heald frames, under the comprehensive mechanized distance

Straight – (variable angle Time) – Fully usual, reed weft point from long distance

Crease: net surface partial folding, forming unrecoverable prints.

Hole: net surface concentration of the warp or weft has a plurality of broken wires.

Rust: net surface corrosion deterioration,

Rust: net surface is green, brown or heterochromatic small spots,
Broken wires: surface warp or weft single network to be disconnected.

Mosquito mouth: metal wire circular motion, kink, empty out the mesh.

Top button: warp bad connector, the top of the mesh.

Shrinking weft: weft partial cubic curved, mesh deformation.

And wire: two or more than two parallel wires woven together.

Wire jump (jump hook): Bureau of warp or weft cloth interwoven error.

Songsi: Individual warp or weft loose displacement.

Debris weaving: weaving foreign body in the net.

Related products

Ask For Quote

Your name

Your email


Translate »